Husqvarna YTH2648 TF owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 25

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thor- oughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTSSUCHASCARBURETOR, FUELFILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Image 25
Contents YTH2648 TF Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Dphg E CJK Know Your TractorAttachment Clutch Switch Disengaged Engaged HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Stop Mower Blades Using the Reverse Operation SystemReverse Operation System ROS See Fig To Operate on HillsBefore Starting the Engine Service REMINDER/HOUR MeterCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig O PSecure with small washer and small retainer spring as shown To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig Belt InstallationFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigReplacing Battery See Fig To Start Engine with a Weak Battery see FIGTo Remove CABLES, Reverse Order Transmission Other StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine continues Wheels and Tires DecalsKEY Part NO. no Description SCH12 SchematicTractor Model NO. YTH2648 TF 96041022500, Product no 41 KEY Part Description ElectricalChassis Tractor Model NO. YTH2648 TF 96041022500, Product no 41 284 DriveTransaxle, Tufftorq K46BT Engine Engine Power Rating Information Steering Assembly 532 42 Seat Seat AssemblyMower Deck Tractor Model NO. YTH2648 TF 96041022500, Product no 41     Mower LiftWhill Only Ride UP and do Hillss Not Acro Axms Reeg DE51 Ggus12.16.10 AP

YTH2648 TF specifications

The Husqvarna YTH2648 TF is a standout riding lawn mower designed for homeowners seeking efficiency, comfort, and longevity in their lawn care endeavors. With a powerful yet reliable engine, advanced features, and user-friendly design, this mower is ideal for tackling medium to large areas with ease.

One of the most notable features of the YTH2648 TF is its robust 24 HP Briggs & Stratton engine. This engine provides ample power to navigate tough terrains and thick grasses, ensuring efficient cutting performance. The mower's hydrostatic transmission delivers seamless speed adjustments without the need for clutching or shifting, allowing operators to maintain momentum and focus on the task at hand.

The cutting deck of the YTH2648 TF measures 48 inches in width, making it suitable for covering expansive areas quickly. It features a reinforced steel construction that enhances durability and extends the lifespan of the mower, even under rigorous use. The mower’s cutting height can be easily adjusted with a lever, offering six different settings from 1.5 to 4 inches, ensuring precise control over grass length.

Comfort is a key consideration in the design of the YTH2648 TF. It comes equipped with an ergonomic seat that provides support during longer mowing sessions, paired with a soft-grip steering wheel that enhances control. The mower's compact design allows for easy maneuverability around obstacles, such as trees and flower beds, while its tight turning radius ensures that no corners are left uncut.

The Husqvarna YTH2648 TF also features innovative technologies such as the Air Induction mowing technology. This system enhances airflow within the deck, resulting in a cleaner and more consistent cut. Additionally, the mower supports a variety of accessories, like mulching kits and baggers, allowing homeowners to customize their lawn care approach to suit their unique needs.

For added convenience, the YTH2648 TF incorporates easy-to-reach controls and an intuitive dashboard that provides information on fuel levels and speed. A durable front bumper offers protection against accidental impacts, contributing to the mower's overall resilience.

Overall, the Husqvarna YTH2648 TF stands out as a reliable riding mower that combines power, precision, and comfort, making it an excellent choice for homeowners looking to achieve a well-maintained, beautiful lawn with ease.