Husqvarna YTH2754T manual Know Your Tractor, Operation

Page 11
KNOW YOUR TRACTOR

OPERATION

KNOW YOUR TRACTOR

READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR

Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.

P

DH

E

G

K

L

NManual background

B

F J

C

A

M

Fig. 14

Our tractors conform to the applicable safety standards of the American National Standards Institute.

(A)ATTACHMENT LIFT LEVER – Used to raise and lower the mower or other attachments mounted to your tractor.

(B)BRAKE PEDAL – Used for braking the tractor and starting the engine.

(C)PARKING BRAKE – Locks clutch/brake pedal into the brake position.

(D)THROTTLE CONTROL – Used to control engine speed.

(E)ATTACHMENT CLUTCH SWITCH – Used to engage the mower blades, or other attachments mounted to your tractor.

(F)IGNITION SWITCH – Used for starting and stopping the engine.

(G)REVERSE OPERATION SYSTEM (ROS) "ON" POSITION

– Allows operation of mower or other powered attachment while in reverse.

(H)LIGHT SWITCH – Turns the headlights on and off.

(J)CRUISE CONTROL LEVER – Used to set forward movement of tractor at desired speed without holding the forward drive pedal.

(K)FORWARD DRIVE PEDAL – Used for forward movement of tractor.

(L)REVERSE DRIVE PEDAL – Used for reverse movement of tractor.

(M)FREEWHEEL CONTROL – Disengages transmission for pushing or slowly towing the tractor with the engine off.

(N)CHOKE CONTROL – Used when starting a cold engine.

(P)SERVICE REMINDER / HOUR METER – Indicates when service is required for the engine and mower.

11

Image 11
Contents YTH2754T Operators ManualII. SLOPE OPERATION SAFETY RULESSafe Operation Practices for Ride-OnMowers I. GENERAL OPERATIONGENERAL SERVICE V. SERVICEIII. CHILDREN IV. TOWING10-16 TABLE OF CONTENTSPRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESSlope Sheet UNASSEMBLED PARTSMower Mower Front WheelTO CHECK BATTERY See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY ADJUST SEAT See FigFIg. LB M TO INSTALL MOWER See FigsASSEMBLE FRONT WHEEL TO MOWER See Fig DC DMOWER DRIVE BELT INSTALLATION CHECK FOR PROPER POSITION OF ALL BELTS ASSEMBLE GAUGE WHEELS TO MOWER DECK See FigCHECK TIRE PRESSURE CHECK DECK LEVELNESSOPERATION KNOW YOUR TRACTOR TO USE THROTTLE CONTROL D See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig STOPPING See FigTO USE CRUISE CONTROL J See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig TO MOVE FORWARD AND BACKWARD See FigTO TRANSPORT See Figs. 14 and TO STOP MOWER BLADESREVERSE OPERATION SYSTEM ROS TO OPERATE ON HILLSADD GASOLINE SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVELPURGE TRANSMISSION MOWING TIPSLUBRICATION CHART MAINTENANCETIRES BATTERYTRACTOR BRAKE OPERATIONTRANSAXLE COOLING CLEAN AIR SCREENENGINE V-BELTSSPARK PLUGS CLEANINGENGINE OIL FILTER MUFFLERTO LEVEL MOWER SERVICE AND ADJUSTMENTSTO INSTALL MOWER TRACTOR See Fig. TO REMOVE MOWERSERVICE AND ADJUSTMENTS TO REPLACE MOTION DRIVE BELT See Fig TO REPLACE MOWER BLADE DRIVE BELTTO CHECK BRAKE TO REMOVE WHEEL FOR REPAIRS See Fig TO START ENGINE WITH A WEAK BATTERY See FigFRONT WHEEL TOE-IN/CAMBER TO ADJUST CHOKE CONTROL REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST THROTTLE CONTROL CABLEENGINE OIL STORAGEOTHER FUEL SYSTEMCAUSE TROUBLESHOOTING POINTSPROBLEM Loss of powerEngine dies when run when operatorBattery will not charge when turning15 DEGREES MAX ONLY RIDE UP AND DOWN HILL NOT ACROSS HILLSERVICE NOTES SERVICE NOTES Charlotte, NC WARRANTY STATEMENT2008