Husqvarna YTH2754T manual To Stop Mower Blades, Reverse Operation System Ros, To Operate On Hills

Page 14
TO STOP MOWER BLADES

OPERATION

TO STOP MOWER BLADES

Disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield

(S) in place (See Fig. 21).

S

Fig. 21

REVERSE OPERATION SYSTEM (ROS)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

(S) in place (See Fig. 21). WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless

absolutely necessary.

USING THE REVERSE OPERATION SYSTEM (SEE FIG. 22) -

Only use if you are certain no children or other bystanders will enter the mowing area.

Move motion control lever to neutral (N) position.

With engine running, turn ignition key counterclockwise to ROS "ON" position.

Look down and behind before and while backing.

Slowly move motion control lever to reverse (R) posi- tion to start movement.

When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 22

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

To restart movement, slowly release parking brake and brake pedal.

Slowly depress appropriate drive pedal to slowest set- ting.

Make all turns slowly.

TO TRANSPORT (See Figs. 14 and 23)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TRANSMISSION ENGAGED

TRANSMISSION DISENGAGED

Fig. 23

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

14

Image 14
Contents Operators Manual YTH2754TI. GENERAL OPERATION SAFETY RULESSafe Operation Practices for Ride-OnMowers II. SLOPE OPERATIONIV. TOWING V. SERVICEIII. CHILDREN GENERAL SERVICECUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS 10-16Mower Front Wheel UNASSEMBLED PARTSMower Slope SheetADJUST SEAT See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO CHECK BATTERY See FigDC D TO INSTALL MOWER See FigsASSEMBLE FRONT WHEEL TO MOWER See Fig FIg. LB MMOWER DRIVE BELT INSTALLATION CHECK DECK LEVELNESS ASSEMBLE GAUGE WHEELS TO MOWER DECK See FigCHECK TIRE PRESSURE CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR STOPPING See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig TO USE THROTTLE CONTROL D See FigTO MOVE FORWARD AND BACKWARD See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig TO USE CRUISE CONTROL J See FigTO OPERATE ON HILLS TO STOP MOWER BLADESREVERSE OPERATION SYSTEM ROS TO TRANSPORT See Figs. 14 andCHECK ENGINE OIL LEVEL SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONMAINTENANCE LUBRICATION CHARTBRAKE OPERATION BATTERYTRACTOR TIRESV-BELTS CLEAN AIR SCREENENGINE TRANSAXLE COOLINGMUFFLER CLEANINGENGINE OIL FILTER SPARK PLUGSTRACTOR See Fig. TO REMOVE MOWER SERVICE AND ADJUSTMENTSTO INSTALL MOWER TO LEVEL MOWERSERVICE AND ADJUSTMENTS TO REPLACE MOTION DRIVE BELT See Fig TO REPLACE MOWER BLADE DRIVE BELTTO CHECK BRAKE TO REMOVE WHEEL FOR REPAIRS See Fig TO START ENGINE WITH A WEAK BATTERY See FigFRONT WHEEL TOE-IN/CAMBER TO ADJUST THROTTLE CONTROL CABLE REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST CHOKE CONTROLFUEL SYSTEM STORAGEOTHER ENGINE OILLoss of power TROUBLESHOOTING POINTSPROBLEM CAUSEwhen turning run when operatorBattery will not charge Engine dies whenONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXSERVICE NOTES SERVICE NOTES Charlotte, NC WARRANTY STATEMENT2008