Husqvarna YTH2754T REPLACING BATTERY See Fig, To Replace Headlight Bulb, Interlocks And Relays

Page 25
REPLACING BATTERY (See Fig. 39)

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 39)

TO REPLACE HEADLIGHT BULB WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent spark- ing from accidental grounding.

•Lift hood to raised position.

•Disconnect BLACK battery cable (A) then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable (B) to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover (C) over terminal.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

•Close hood.

A

Negative (Black)

Cable

 

C

Positive B (Red)

Cable

02954 INTERLOCKS AND RELAYS

Fig. 39

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 40)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03076

Fig. 40

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents YTH2754T Operators ManualSafe Operation Practices for Ride-OnMowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING GENERAL SERVICEPRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES 10-16Mower UNASSEMBLED PARTSMower Front Wheel Slope SheetTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYADJUST SEAT See Fig TO CHECK BATTERY See FigASSEMBLE FRONT WHEEL TO MOWER See Fig TO INSTALL MOWER See FigsDC D FIg. LB MMOWER DRIVE BELT INSTALLATION CHECK TIRE PRESSURE ASSEMBLE GAUGE WHEELS TO MOWER DECK See FigCHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR TO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORSTOPPING See Fig TO USE THROTTLE CONTROL D See FigTO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO MOVE FORWARD AND BACKWARD See Fig TO USE CRUISE CONTROL J See FigREVERSE OPERATION SYSTEM ROS TO STOP MOWER BLADESTO OPERATE ON HILLS TO TRANSPORT See Figs. 14 andBEFORE STARTING THE ENGINE SERVICE REMINDER/HOUR METERCHECK ENGINE OIL LEVEL ADD GASOLINEPURGE TRANSMISSION MOWING TIPSLUBRICATION CHART MAINTENANCETRACTOR BATTERYBRAKE OPERATION TIRESENGINE CLEAN AIR SCREENV-BELTS TRANSAXLE COOLINGENGINE OIL FILTER CLEANINGMUFFLER SPARK PLUGSTO INSTALL MOWER SERVICE AND ADJUSTMENTSTRACTOR See Fig. TO REMOVE MOWER TO LEVEL MOWERSERVICE AND ADJUSTMENTS TO CHECK BRAKE TO REPLACE MOWER BLADE DRIVE BELTTO REPLACE MOTION DRIVE BELT See Fig FRONT WHEEL TOE-IN/CAMBER TO START ENGINE WITH A WEAK BATTERY See FigTO REMOVE WHEEL FOR REPAIRS See Fig TO REMOVE HOOD AND GRILL ASSEMBLY See Fig REPLACING BATTERY See FigTO ADJUST THROTTLE CONTROL CABLE TO ADJUST CHOKE CONTROLOTHER STORAGEFUEL SYSTEM ENGINE OILPROBLEM TROUBLESHOOTING POINTSLoss of power CAUSEBattery will not charge run when operatorwhen turning Engine dies when15 DEGREES MAX ONLY RIDE UP AND DOWN HILL NOT ACROSS HILLSERVICE NOTES SERVICE NOTES 2008 WARRANTY STATEMENTCharlotte, NC
Top Page Image Contents