Husqvarna YTH2754T manual Storage, Other, Fuel System, Engine Oil, Cylinders, Tractor, Battery

Page 26
STORAGE

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Image 26
Contents Operators Manual YTH2754TI. GENERAL OPERATION SAFETY RULESSafe Operation Practices for Ride-OnMowers II. SLOPE OPERATIONIV. TOWING V. SERVICEIII. CHILDREN GENERAL SERVICECUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS 10-16Mower Front Wheel UNASSEMBLED PARTSMower Slope SheetADJUST SEAT See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO CHECK BATTERY See FigDC D TO INSTALL MOWER See FigsASSEMBLE FRONT WHEEL TO MOWER See Fig FIg. LB MMOWER DRIVE BELT INSTALLATION CHECK DECK LEVELNESS ASSEMBLE GAUGE WHEELS TO MOWER DECK See FigCHECK TIRE PRESSURE CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR STOPPING See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig TO USE THROTTLE CONTROL D See FigTO MOVE FORWARD AND BACKWARD See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig TO USE CRUISE CONTROL J See FigTO OPERATE ON HILLS TO STOP MOWER BLADESREVERSE OPERATION SYSTEM ROS TO TRANSPORT See Figs. 14 andCHECK ENGINE OIL LEVEL SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONMAINTENANCE LUBRICATION CHARTBRAKE OPERATION BATTERYTRACTOR TIRESV-BELTS CLEAN AIR SCREENENGINE TRANSAXLE COOLINGMUFFLER CLEANINGENGINE OIL FILTER SPARK PLUGSTRACTOR See Fig. TO REMOVE MOWER SERVICE AND ADJUSTMENTSTO INSTALL MOWER TO LEVEL MOWERSERVICE AND ADJUSTMENTS TO REPLACE MOTION DRIVE BELT See Fig TO REPLACE MOWER BLADE DRIVE BELTTO CHECK BRAKE TO REMOVE WHEEL FOR REPAIRS See Fig TO START ENGINE WITH A WEAK BATTERY See FigFRONT WHEEL TOE-IN/CAMBER TO ADJUST THROTTLE CONTROL CABLE REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST CHOKE CONTROLFUEL SYSTEM STORAGEOTHER ENGINE OILLoss of power TROUBLESHOOTING POINTSPROBLEM CAUSEwhen turning run when operatorBattery will not charge Engine dies whenONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXSERVICE NOTES SERVICE NOTES Charlotte, NC WARRANTY STATEMENT2008