Husqvarna YTH2648TDRF Transmission, Interlocks And Relays, REPLACING BATTERY See Fig, Engine

Page 25
INTERLOCKS AND RELAYS

SERVICE AND ADJUSTMENTS

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring.

WEAK OR

FULLY CHARGED

DEAD BATTERY

BATTERY

Fig. 39

REPLACING BATTERY (See Fig. 40)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal cover.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal cover.

•First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely

•Close hood.

NEGATIVE (BLACK)

CABLE

TERMINAL

COVER REPLACING BATTERY (See Fig. 40)TO REPLACE HEADLIGHT BULBTO REPLACE FUSETO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 41)

POSITIVE (RED)

CABLE

Fig. 40 TRANSMISSION

TO REPLACE HEADLIGHT BULB

• Raise hood.

• Pull bulb holder out of the hole in the backside of the grill.

• Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

• Close hood.

25

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 41)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

07002

Fig. 41

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperatingthetractor. See“PURGETRANSMISSION” in the Operation section of this manual.

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjust- ment should not be necessary. If adjustment is necessary, see engine manual.

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Owners Manual YTH2648TDRF532 44 40-19 Rev 07002Safe Operation Practices for Ride-On Mowers SAFETY RULESGENERAL SERVICE III. CHILDRENSAFE HANDLING OF GASOLINE PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES SERVICE AND ADJUSTMENTSTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYTO CHECK BATTERY See Fig ADJUST SEAT See FigCHECK DECK LEVELNESS CHECK TIRE PRESSURECHECK FOR PROPER POSITION OF ALL BELTS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR TO SET PARKING BRAKESee Fig HOW TO USE YOUR TRACTORSTOPPING See Fig TO USE THROTTLE CONTROL D See Fig.6TO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO MOVE FORWARD AND BACKWARD See Fig K J LTO STOP MOWER BLADES SERVICE REMINDER/HOUR METERREVERSE OPERATION SYSTEM ROS TO OPERATE ON HILLSBEFORE STARTING THE ENGINE BATTERY INDICATOR/CHARGING PLUG See FigCHECK ENGINE OIL LEVEL ADD GASOLINEPURGE TRANSMISSION TO START ENGINE See FigMOWING TIPS MAINTENANCE MAINTENANCEGENERAL RECOMMENDATIONS SCHEDULETRACTOR BATTERYBLADE CARE BLADE REMOVAL See FigENGINE TRANSAXLE MAINTENANCEV-BELTS TRANSAXLE PUMP FLUIDCLEAN AIR SCREEN CLEANINGAIR FILTER ENGINE COOLING SYSTEMPluganyholesinmowerwithboltsandlocknuts DECK WASHOUT PORT See FigTO INSTALL MOWER See Fig SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig A C D C DSERVICE AND ADJUSTMENTS TO LEVEL MOWER TO CHECK BRAKE TO REPLACE MOWER BLADE DRIVE BELTIDLER ARM BELT ROUTING ENGINE BLADE BELTTO REPLACE MOTION DRIVE BELT See Fig TO START ENGINE WITH A WEAK BATTERY See FigFRONT WHEEL TOE-IN/CAMBER TO REMOVE WHEEL FOR REPAIRS See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig REPLACING BATTERY See FigREMOVAL/REPLACEMENT TO ADJUST THROTTLE CONTROL CABLEOTHER STORAGEFUEL SYSTEM ENGINE OILPROBLEM TROUBLESHOOTINGCAUSE CORRECTIONEngine continues to SERVICE NOTES DECALS TRACTOR - MODEL NO. YTH2648TDRF 96041026400, PRODUCT NO. 960WHEELS AND TIRES KEY PARTTRACTOR - MODEL NO. YTH2648TDRF 96041026400, PRODUCT NO. 960 41 SCHEMATICPTO SWITCH IGNITION SWITCHELECTRICAL TRACTOR - MODEL NO. YTH2648TDRF 96041026400, PRODUCT NO. 960 41With Service Minder Option With Charge Indicator OptionPART chassis-texGT HUSQ II94r1 CHASSISCHASSIS drive-texK46pedal71r3 DRIVESpacer Split 532 13ENGINE SPARK ARRESTER KITEngine Power Rating Information steering-texTTR7 STEERING ASSEMBLYAxle Asm., Front 532 44 SEAT ASSEMBLYSeat        MOWER LIFT       48Felec-Tex5 MOWER DECKMOWER DECK TRACTOR - MODEL NO. YTH2648TDRF 96041026400, PRODUCT NO. 960 41PART DESCRIPTIONSERVICE NOTES SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXPrinted in the U.S.A 04.02.13 JM
Top Page Image Contents