Husqvarna YTH2242TDF Before Starting the Engine, Service REMINDER/HOUR Meter, ADD Gasoline

Page 12

OPERATION

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in

this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

RESERVE FUEL VALVE OPERATION (See Fig. 12)

1.Raise seat to access reserve fuel valve.

2.In normal operation, valve should be set to primary (as shown in view)

3.If tractor runs out of fuel, rotate valve handle to reserve.

4.Drive tractor to be refueled.

5.After refueling, return valve to primary position.

RESERVE

FUEL VALVE

RESERVE

PRIMARY

Fig. 12

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F / 10°C and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F / 10°C and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents YTH2242TDF Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor CJKHOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking BRAKESee Fig Stopping See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Stop Mower Blades Reverse Operation System ROSTo Operate on Hills To Transport See FigService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Raise attachment lift lever to highest position To Level Mower To Replace Mower Blade Drive Belt To Check BrakeTo Start Engine with a Weak Battery See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesSchematic SCH12Electrical KEY Part Description 196 Chassis 207 Drive Spark Arrester KIT EngineEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering Seat Assembly 532 42 SeatDecals Wheels and TiresMower Deck Tractor Model NO. YTH2242TDF 96041017302, Product no 41 Mower Lift 532 40 34-07 Link Lift Susp Mower RearSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX12.01.10 CL/SR

YTH2242TDF specifications

The Husqvarna YTH2242TDF is a robust and reliable riding mower designed for homeowners seeking a machine that combines power, efficiency, and ease of use. Packed with essential features and advanced technologies, this mower stands out for its performance and versatility in tackling landscaping tasks.

One of the key features of the YTH2242TDF is its powerful 18.5 HP Briggs & Stratton engine. This durable engine ensures consistent performance, allowing users to navigate their lawns with ease. The Hydrostatic transmission further enhances this experience, providing a smooth and effortless driving experience without the need for manual gear changes. This user-friendly design enables operators of all skill levels to maneuver effectively and efficiently around their property.

The cutting deck of the YTH2242TDF measures 42 inches, making it suitable for medium to large sized lawns. This size allows for a wide cutting path, reducing the time needed to mow. The deck features a washing port, making maintenance a breeze by allowing users to easily clean the underside of the deck after mowing, helping to maintain optimal cutting efficiency.

Additionally, the mower is equipped with a compact design that provides excellent visibility and maneuverability in tight spaces. Its tight turning radius enables users to navigate landscaping features with precision, reducing the need for excessive trimming afterwards.

Another noteworthy attribute of the YTH2242TDF is its comfort features. The adjustable seat ensures that operators can find their ideal position, while ergonomic controls reduce fatigue during extended use. The easy-access controls are designed to enhance user comfort and efficiency, making the mowing experience more enjoyable.

For added versatility, the YTH2242TDF is compatible with a variety of attachments, including baggers, plows, and mulchers, making it an excellent investment for seasonal tasks beyond mowing. This flexibility allows users to maximize the utility of their mower throughout the year.

In terms of build quality, Husqvarna's commitment to durability is evident in the robust construction of the YTH2242TDF. The cutting deck is made from high-quality steel, ensuring it can withstand the rigors of regular use.

In summary, the Husqvarna YTH2242TDF is an exceptional choice for homeowners looking for a reliable, efficient, and easy-to-use riding mower. With its powerful engine, smooth transmission, and versatile design, it stands out as a valuable tool for maintaining beautiful lawns.
Top Page Image Contents