Husqvarna YTH2242TDF owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Maintenance section of this manual).

Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Maintenance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Image 24
Contents YTH2242TDF Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor CJKHOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking BRAKESee Fig Stopping See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Stop Mower Blades Reverse Operation System ROSTo Operate on Hills To Transport See FigService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Raise attachment lift lever to highest position To Level Mower To Replace Mower Blade Drive Belt To Check BrakeTo Start Engine with a Weak Battery See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesSchematic SCH12Electrical KEY Part Description 196 Chassis 207 Drive Spark Arrester KIT EngineEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering Seat Assembly 532 42 SeatDecals Wheels and TiresMower Deck Tractor Model NO. YTH2242TDF 96041017302, Product no 41 Mower Lift 532 40 34-07 Link Lift Susp Mower RearSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX12.01.10 CL/SR

YTH2242TDF specifications

The Husqvarna YTH2242TDF is a robust and reliable riding mower designed for homeowners seeking a machine that combines power, efficiency, and ease of use. Packed with essential features and advanced technologies, this mower stands out for its performance and versatility in tackling landscaping tasks.

One of the key features of the YTH2242TDF is its powerful 18.5 HP Briggs & Stratton engine. This durable engine ensures consistent performance, allowing users to navigate their lawns with ease. The Hydrostatic transmission further enhances this experience, providing a smooth and effortless driving experience without the need for manual gear changes. This user-friendly design enables operators of all skill levels to maneuver effectively and efficiently around their property.

The cutting deck of the YTH2242TDF measures 42 inches, making it suitable for medium to large sized lawns. This size allows for a wide cutting path, reducing the time needed to mow. The deck features a washing port, making maintenance a breeze by allowing users to easily clean the underside of the deck after mowing, helping to maintain optimal cutting efficiency.

Additionally, the mower is equipped with a compact design that provides excellent visibility and maneuverability in tight spaces. Its tight turning radius enables users to navigate landscaping features with precision, reducing the need for excessive trimming afterwards.

Another noteworthy attribute of the YTH2242TDF is its comfort features. The adjustable seat ensures that operators can find their ideal position, while ergonomic controls reduce fatigue during extended use. The easy-access controls are designed to enhance user comfort and efficiency, making the mowing experience more enjoyable.

For added versatility, the YTH2242TDF is compatible with a variety of attachments, including baggers, plows, and mulchers, making it an excellent investment for seasonal tasks beyond mowing. This flexibility allows users to maximize the utility of their mower throughout the year.

In terms of build quality, Husqvarna's commitment to durability is evident in the robust construction of the YTH2242TDF. The cutting deck is made from high-quality steel, ensuring it can withstand the rigors of regular use.

In summary, the Husqvarna YTH2242TDF is an exceptional choice for homeowners looking for a reliable, efficient, and easy-to-use riding mower. With its powerful engine, smooth transmission, and versatile design, it stands out as a valuable tool for maintaining beautiful lawns.