Remote controller display
| Operation mode | |
| indicator | |
Set temperature/time | Low battery indicator | |
indicator | ||
| ||
On/Off timer indicator | Transmit indicator | |
| ||
Fan speed indicator |
| |
Auto | Air swing indicator | |
Low |
| |
Medium |
| |
High |
|
When the Heat mode is selected Heat mode indicator will be displayed on the remote controller and the indoor unit will make sound, but your air conditioner is not actually operating in Heat mode.
If you turn on the air conditioner after turning it off with the Heat mode selected on the remote controller, it will operate in Auto mode but the remote controller will still show Heat mode on the display. Press the Mode button to match the mode indicator on the remote controller.
Using the remote controller
•Point the remote controller towards the remote controller receiver of the indoor unit (see page 11 to find the location of remote control receiver).
•When you properly press the button on the remote controller, you will hear ring sound from the indoor unit.
•The signal may not be received well of electronic lighting style fluorescent lamps such as inverter fluorescent lamps are in the same space.
•If other electrical products operate by the remote controller, call your nearest contact center.
Installing the batteries
1. Push the lever as arrow | 2. Insert two AAA batteries. | 3. Close the cover by place | |
indicates on the rear side | Check and match the “+” | it back to its original | |
of the remote controller | position. | ||
and | |||
and pull up. |
| ||
Make sure you have inserted | You should hear click sound | ||
| |||
| the batteries in correct | when the cover is locked | |
| position. | properly. | |
|
|
|