Samsung SSA-M1000 SSA-M1000/EXP system management, 80_ system management

system management

Function Name	Descriptions
Anti-passback	Antipassback limits door access only when entering and exiting matches if a door is installed with two separate
	readers both for entering and exiting respectively. In general, this function is used for preventing entering a door by
	following the previous authorization.
Door Open Alarm Time	You can set the delay time until the product triggers the door open alarm if the door stays open after the Door Relay
	time. This function requires Door Contact Sensors installed.
Voice mode	You can set to play recorded voice guide.
Voice Mode Time	You can set time schedule for voice mode, which will play recorded voice guide only within the specified time table.
Schedule
Duress Mode	Duress mode requires the Duress Mode Password for enabling this function. Duress mode is a special feature that
	outputs a special tacit alarm signal when it is forced to open the restricted area, by entering 2-digit code before
	authorizing. The door opens as normally but the program generates duress event which will trigger the alert.
Duress Mode Password	The 2-digit password to trigger the Duress mode.
Arm/Disarm	Alarm controllers of other manufacturers can be connected through the access controller’s output if required. At the
	moment, if armed with the ARM code and ARM card, it can be configured to make all access controllers of doors to
	deny any access requests.
Arm/Disarm Input	If you intend to use the Arm function, you can set the Arm function via a specific input point instead of using the card.
Enable
Arm Code	This is a two-digit code required to set the arm function.
Disarm Code	This is a two-digit code required to release the arm function.
Two Men Mode Enable	Enable this when two men operation mode (for administrator and visitor) is required. With the two men operation
	mode activated, the door will be opened if both administrator and visitor card issued in card holder management are
	entered in a row.

J Duress mode and Arm/Disarm will require keypad readers (SSA-R2000, SSA-R2001, etc.) if used with the SSA- P102 and 400 series products.

14.Move to the [Controller Option] tab.

80_ system management