Device Setting Wizard – Communication Type
1.Select the communication type. Select either one of [Serial Communication] or [Network Communication].
2.Select the desired communication type and click [Next] button.
Device Setting Wizard – Loop Setting (Serial Communication)
1.This is for serial communication settings. For network communication settings, refer to the Network Communication section.
2.Click [Loop Setting] to add a loop. Enter the [Loop]. Enter the [Communication Port] that is used for communication to the device. Enter the baud rate of the device to [Speed]. Check your device and specify the value properly, since the baud rate differs from devices. When you complete your selection, press the [Save] button.
3.Once completed with adding a loop, select the desired loop and click [Next] button. (When a message of “Restart the communication server?” appears, Click [Yes(Y)].)
MANAGEMENT SYSTEM