179
Basic MIDI settings
LS9-16/32 Owner’s Manual
18
MIDI
GCONTROL CHANGE MODE field
Here you can select the control change transmission/
reception mode.
●NRPN button
If this button is on, the LS9’s mix parameters will
be transmitted/received as NRPN messages on one
MIDI channel (NRPN mode).
●TABLE button
If this button is on, the LS9’s mix parameters will
be transmitted/received as control change mes-
sages on one MIDI channel (TABLE mode).
HPARAMETER CHANGE field
Here you can make settings for transmission/reception
of “parameter change” system exclusive messages.
●Tx button
Switches parameter change transmission on/off.
●Rx button
Switches parameter change reception on/off.
●ECHO button
This selects whether incoming parameter changes
are echoed-out from the transmission port.
IOTHER COMMAND field
Here you can specify how MIDI messages other than
program changes, control changes, and parameter
changes (i.e., messages such as note-on/off and MIDI
timing clock) will be received.
●ECHO button
Selects whether other MIDI messages that are
received will be echoed out from the transmit port.
3To specify the port that will transmit or
receive each type of MIDI message, move
the cursor to the transmit (Tx) or receive
(Rx) port selection box, use the dial or the
[DEC]/[INC] keys to specify the setting, and
then press the [ENTER] key.
You can choose from the following items.
4To specify the channel (CH1–CH16) on
which MIDI messages will be transmitted or
received, move the cursor to the channel
selection box, use the dial or the [DEC]/
[INC] keys to specify the setting, and press
the [ENTER] key.
5Turn transmission/reception on or off for
each MIDI message.
Item Description
---- No port will be used.
MIDI Rear panel MIDI IN (Rx) / OUT (Tx)
connector
SLOT {1/2} -1–8
(The number of available
ports will depend on the
card that is installed.)
A card that supports serial trans-
mission, installed in a rear panel
slot {1/2} (MY16-CII is valid in
SLOT {1–2})
• When transmitting or receiving parameter changes, the chan-
nel number you specify here is used as the device number (a
number that identifies the transmitting or receiving unit).
HINT
•For details on using program changes, refer to “Using pro-
gram changes to recall scenes and library items,” below.
•For details on using control changes, refer to “Using control
changes to control parameters” (
→
p. 183).
HINT