Contents
Main
Page
General Description
output has a balanced, low impedance, transformer-isolated, XLR connector, and an
input detects excessive inputs and helps avoid clipping. A p an control on each input
output and echo send allows monitoring the respective, pre-fader (pre-volume)
Features
unbalanced 1/4" jack on each input channel and line input.
5. Four-band equalizer on each input channel.
or foldback outputs.
other auxiliary equipment.
Front Panel, Input Section
The input trim varies the gain of the pre-amplifier stage of each input channel, providing a
The high control in each input channel alters th e frequency response of t he channel input,
having flat audio response at the detented "0" position.
This control assigns the fader output signal of the channel to the Program L, R mixing busses.
Front Panel, Output Section
- 4 -
Meter Panel RX-208, RX-212
Caution
- 5 -
The graphic equalizer is normally used for either the PGM or FB mix. For normal operation, only one
button should be pressed. If the equalizer is not being used, the "OFF" button should be depressed.
Rear Panel (RX-208)
RX-208
6
plugs are inserted into these jacks, the input
interrupts the return signal from the built-in echo
Rear Panel (RX-212, RX-216)
The RX-212 and RX-216 are the same as the RX-208 in functions, except that the RX-212 has
- 7 -
12 input channels and the RX-216 has 16 input channels.
RX-212
Connection Example
level must be adjusted by the in-
- 8 -
Unbalanced input jacks ac-
The stereo input switch on the front panel must be set at t he "PHONO" position.
Page
How to use ''channel patching" accessory jack
The accessory jack (Tip, Ring, Sleeve) is provided on each input channel to allow insertion of
Inserting a plug into the jack interrupts normal signal flow and places the external device into
the circuitry just prior to the input equalizer section. (See Fig. 1.)
connection to a multi-track tape deck or use as an additional effects mix.
How to get a good mixing
gain of the head amp can also be changed. Because of this,
ensured. Also, S/N ratio will be better by decreasing the
Channel and Graphic Equalizers
Equalization for music
- 13 -
Table 1
Figure 1
Channel and Graphic Equalizers
- 14 -
the system response has peaks. Suppose the system has uneven frequency response like that
shown in the following diagram.
equalizer. If the overall gain is again gradually increased, feedback will occur next at about
Input & Output Specifications
INPUT SPECIFICATIONS
-
OUTPUT SPECIFICATIONS
SUB IN