Rear Panel (RX-208)
RX-208
Program Line Output Connectors and Jacks
(LINE OUT, PGM L, R)
These connectors and jacks are the outputs
of the console deriving the signals after each
program master fader. The XLR connectors are balanced,
phone jacks are unbalanced, with an output impedance and nominal level of 600 ohms and +4dB, respectively.
Power Switch (POWER)
This switch provides AC power to the console. Power should only be applied after all audio connections have been completed.
Power Fuse
Power Cord
Ground Terminal (GND)
The chassis must be grounded.
Foldback Line Output Connectors and Jacks
(LINE OUT FB 1, 2)
These connectors and jacks are the foldback outputs deriving the signals after each foldback master fader. The XLR connectors
are balanced,
with an output impedance and nominal level of 600 ohms and +4dB, respectively. The
phone jacks are unbalanced, with an output
impedance and nominal level of 600 ohms
and +4dB, respectively.
Echo Output Jacks (ECHO SEND)
These jacks are unbalanced, with an output
impedance of 600 ohms. One jack is for +4dB
output and the other is for
echo machines. The +4dB jack can be used for output cascading.
Phantom Power Switches (PHANTOM 1~8)
The phantom power switch on each input channel permits the user to supply 48V DC through
the input connectors to a con-
denser microphone. If phantom
power is not required, the
switch must be in the "off" posi- tion.
Sub Input Jacks
(SUB IN PGM L, R, FB 1 , 2, ECHO)
These five jacks are directly connected to the
corresponding mixing busses (program L, R,
FB1, 2, and echo), and are provided for
cascade connection to expand the input
capacity.
Accessory Send/Receive Jacks
(ACCESSORY 1~8)
These jacks are provided as patching points for inserting signal processing equipment such as compressor/limiters, noise gate, etc. An output impedance of the accessory send and an input impedance of the accessory receive are 10k ohms. Both nominal signals levels are 0dB. Please refer to the detailed explanation on page 11.
Channel Input, Unbalanced Jacks
(CHANNEL IN UN-BAL 1~8)
These 8 standard 1/4" phone jacks are unbalanced with an input level of
Channel Input, Balanced Connectors
(CHANNEL IN BAL 1~8)
The XLR connectors are balanced, trans-
are employed, the input level switch on the front panel must be set at the "BAL" posi-
tions. Proper adjustment of both input level
switch and trim control make it possible to
provide the optimum setting for each input.
Ground Terminals (GND)
These may be used to provide ground connection
for tape decks or turntables.
Stereo Input Pin Jacks (STEREO IN 1, 2)
Each stereo input has both AUX input and PHONO input pin jacks that are switchable on the front panel. RIAA equalization is provided on the
phono input for accepting turntables with
magnetic cartridges.
Recording Output Pin Jacks
(REC OUT, PGM L, R)
The jacks are unbalanced and provide
Auxiliary Echo Input Jack (AUX ECHO IN)
This standard phone jack is unbalanced and
accepts low or high impedance sources at nominal
mixing busses. Inserting a plug in the jack interrupts the return signal from the
controlled by the echo return volume on the front
panel.
– 6 –
