2Wire s8300, g700 manual Equipment and Software Validated, Siemens Hicom

2. Equipment and Software Validated:

The configuration used to test performance of this solution was established in an Avaya Lab setting within the guidelines and use parameters allowed in the user licenses acquired with the equipment and software listed below.

Platform	Version
Avaya MultiVantage Software	1.2
Avaya S8300 Media Server	213.0
Avaya G700 Media Gateway	3.12
Avaya™ 4612 IP Phones	46XXCommon.V36
Avaya™ 4624 IP Phones	46XXCommon.V36
Avaya MM710 T-1 Interface	Firmware version 5
Siemens Hicom 300 30 EP	Release 9006.5
DSC80 Processor	Firmware version D961-D
TMDN64P T-1 Interface (Q2484-X)	Firmware version D467-C
Optiset E Digital Advanced Plus Phones	Model 69671

3. Requirements:

Avaya S8300 Media Server and an Avaya G700 Media Gateway:

Software:

1.	Avaya MultiVantage Software	Release 1.2	or newer
2.	G700 Media Gateway Firmware	Release 3.12	or newer
3.	S8300 Media Server Software	Release 213.0	or newer

Hardware:

1.MM710 DS1 Circuit pack. Installer needs to determine the number of trunks cards that will be needed for traffic requirements. Consideration must be made for the available slots and resources of the Hicom.

2.T-1 Interface cable. Connects the MM710 T-1 RJ45 interface port or the TN464 DS1 circuit pack to the Hicom. The actual cable needs to be custom built.

Siemens Hicom 300:

For this application to be successful, the intended switch must have:

1.Available slots for the T-1 boards.

2.Available purchased software ports for the T-1 spans.

3.T-1 boards must be compatible to software version.

4.If software or port capacities need to be upgraded, there are two options.

a.Siemens can be contacted and they will upgrade the system.

b.The software on DAT tape is purchased from Siemens or a vendor. The customer loads the software.

Jsl	© 2002 Avaya Inc All Rights Reserved	IP Enabling Siemens
		Hicom with Avaya
		MultiVantage Solutions
LPH 11-27-02		3