Board Parts, Jumpers and Connectors
COM2 Header (J42)
J42
COM2 Header
Use these pin definitions to connect a port to COM2
Signal | Pin | Pin | Signal |
Data Carrier Detect | 1 | 2 | |
3 | 4 | ||
5 | 6 | ||
Data Terminal Ready | 7 | 8 | |
Ground | 9 | 10 | NC/KEY |
Front Panel Audio Header (J43)
J43
Front Panel Audio Header
If you remove the front panel audio cable you have to put jumpers on Pin 5&6 and Pin 9&10 to get audio or microphone signals on your front or rear audio connections.
Signal | Pin | Pin |
MIC In FP | 1 | 2 |
MIC BIAS | 3 | 4 |
Right Front out | 5 | 6 |
No Connect | 7 | 8 |
Left Front Out | 9 | 10 |
Signal
Audio GND
Audio Analog
Right Rear In
Key
Left Rear In
WARNING: Do not place jumpers on this header in any other configuration. Doing so could result in damage to the motherboard!
9 |
