6 Installing NetWare Drivers
64
Verifying the Installation and Configuration
To verify that the driver has been properly loaded on the NetWare server, perform the
following procedure:
1At the system prompt, enter:
load monitor
The NetWare Monitor screen appears.
2From the Available Options menu, select LAN/WAN Drivers.
The Available LAN Driver menu appears. If the driver has been properly loaded, the
driver and frame types associated with the driver appear on this menu.
3Select a driver to view its associated statistics.
A functioning driver displays packets being sent and received.
To verify that the server is communicating over the network, complete the following
procedure:
1Set up a NetWare client on a LAN supported by the server to be tested.
2Log in or map to the server.
If you cannot log in or map to the server, the link is not functional.
If the link is functional, the following message appears:
Link integrity test for primary slot #XXXXX passed.
load se
load lbrsl
;Define primary NIC slot-frame instances
load 3c99x slot=10001 frame=ethernet_802.2 name=p1_802.2
load 3c99x slot=10001 frame=ethernet_ii name=p1_ii
;Define secondary NIC slot-frame instances
load 3c99x slot=10002 frame=ethernet_802.2 name=p2_802.2
load 3c99x slot=10002 frame=ethernet_ii name=p2_ii
;Bind protocols to primary NIC
bind ipx to p1_802.2 net=FF02
bind ip to p1_ii address=192.1.1.1 mask=ff.ff.ff.00
;Create a group with NIC 10001 primary and NIC 10002
secondary
lbrsl group lb 10001 10002
;To create a resilient server link group without load
balancing (for
;use with NICs from manufacturers other than 3Com) use the
rsl option:
;lbrsl group rsl 10001 10002