94 CHAPTER 5: ETHERNET CONFIGURATION COMMANDS
port storm-control include-multicast (GC)The port storm-control include-multicast Interface Configuration
mode command enables counting multicast packets in the port
storm-control broadcast rate command. To disable counting multicast
packets, use the no form of this command.
Syntax
port storm-control include-multicast
no port storm-control include-multicast
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
InBcastPkts Counted received broadcast packets.
OutOctets Counted transmitted octets.
OutUcastPkts Counted transmitted unicast packets.
OutMcastPkts Counted transmitted multicast packets.
OutBcastPkts Counted transmitted broadcast packets.
FCS Errors Counted received frames that are an integral number of
octets in length but do not pass the FCS check.
Single Collision
Frames
Counted frames that are involved in a single collision, and
are subsequently transmitted successfully.
Late Collisions Number of times that a collision is detected later than one
slotTime into the transmission of a packet.
Excessive Collisions Number of excessive collisions received on the selected
interface.
Oversize Packets Counted frames received that exceed the maximum
permitted frame size.
Internal MAC Rx
Errors
Counted frames for which reception fails due to an
internal MAC sublayer received error.
Received Pause
Frames
Counted MAC Control frames received with an opcode
indicating the PAUSE operation.
Transmitted Pause
Frames
Counted MAC Control frames transmitted on this
interface with an opcode indicating the PAUSE operation.
Field Description