3Com Hardware Installation, Installing the 3CRWE920G73 Indoor Wireless Bridge, On a wall

3 Hardware Installation

Installing the 3CRWE920G73 Indoor Wireless Bridge

On a flat surface

1Find a surface that is clear of debris.

2Set the bridge down on its four rubber feet.

On a wall

1Use the mounting template as a guide to make two marks 7.40cm (2.91 inches) apart on the wall. Use the vertical line on the template to ensure that the placement of the marks is plumb to the wall.

2Drill holes at the marks.

Use a 5-mm (3/16-inch) drill bit if using the provided screw anchors; use a 3-mm (1/8-inich) drill bit if using the screws only.

3Install the two flathead screws at the marks on the wall.

Leave the screw heads protruding 6-mm (1/4 inch) from the surface of the wall.

4Hang the bridge on the screws, using the mounting holes on the back of the bridge.

On an acoustical ceiling

1Attach the mounting bracket to the back of the bridge with two number 6 panhead screws.

2Align the T-rail grips with the ceiling T-rail, and adjust them so that they grip the T-rails securely.

3Tighten the screws on each T-rail grip.

After installation, there may be some play in the fit of the T-rail grips if the T-rails are very narrow. If necessary, add a shim to achieve a secure grip.

3Com Corporation Page 3