3-7
z The filter-policy import command filters the RIP routes received from neighbors, and the routes
being filtered out will neither be added to the routing table nor be advertised to any neighbors.
z The filter-policy export command filters all the routes to be advertised, including the routes
redistributed with the import-route command and routes learned from neighbors.
z You can also use the filter-policy export command to filter outgoing routes redistributed from a
specified routing protocol.
Setting RIP preference
Follow these steps to set RIP preference:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Set the RIP preference preference value Required
100 by default
Enabling load sharing among RIP interfaces
Follow these steps to enable load sharing among RIP interfaces:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Enable load sharing among
RIP interfaces traffic-share-across-interf
ace
Required
Disabled by default
Configuring RIP to redistribute routes from another protocol
Follow these steps to configure RIP to import routes from another protocol:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Configure a default cost for
an incoming route default cost value Optional
1 by default
Configure RIP to
redistribute routes from
another protocol
import-route protocol [ cost
value | route-policy
route-policy-name ]*
Required
By default, RIP does not redistribute
any route from other protocols.