3Com 6000 manual User, Documentation

12LANPLEX® 6000 EXTENDED SWITCHING SOFTWARE

	Example of the software installation prompts.
	Host IP address [192.9.200.14]:192.9.200.96
	Install file pathname [/usr/lp6000R/lp6000R]:
	User name: ronnyk
	Password:
	After the software is loaded, this message appears:
	Installation complete.
	If the LANplex executable software image stored in flash memory is cor-
	rupted (for example, when a power failure occurs while you are updating
	software), contact 3Com Technical Support.
6	To reboot the system to use the newly loaded software, enter:
	system reboot
	You are prompted with the following message:
	Are you sure you want to reboot the system (n,y) [y]:
7	At the prompt, enter y for (yes).
	You are now ready to configure management access for your system. For
	information on configuring management access for the LANplex system,
	see the LANplex 6000 Getting Started guide.
User	This version of software is compatible with the documentation revisions
Documentation	listed below. These release notes describe only the changes and additions
	to the following documentation, which comprise the LANplex 6000 system
	documentation set:
■	LANplex 6000 Getting Started (Rev. 01, Part No. 800-00252-000)
■	LANplex 6000 Control Panel User Guide (Rev. 01, Part No. 801-00255-000)
■	LANplex 6000 Operation Guide (Rev. 02, Part No. 801-00253-000)
■	LANplex 6000 Administration Console User Guide (Rev. 01, Part No.
	801-00254-000)
■	LANplex 6000 Command Quick Reference (Folded card; Rev. 01, Part No.
	801-00258-000)
■	LANplex 6000 Extended Switching User Guide (Rev. 01, Part No.
	801-00257-000)