![](/images/new-backgrounds/1265257/26525765x1.webp)
Connecting Devices to the ATM Ports
You can connect devices to the ATM ports either through the building wiring or by a direct connection.
Via Building Wiring
To connect an ATM device via building wiring, follow the steps listed below.
Note: This | procedure | begins | with the | cabling | of | the | ATM device (such as a | ||||||||
ATM adapter installed in a workstation) to the building | faceplate; | then | it | describes | |||||||||||
connecting | the | ONcore | switching hub | or | CELLplex | 4000 to | the | patch | panel | in | the | wiring | |||
closet. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| 1 Look at | the | cabling | chart, | which your | network | planner provided, | to | determine | ||||||
| how the ONcore switching hub or CELLplex | 4000 should | be connected | to | the | ||||||||||
| network. |
|
|
|
|
|
|
|
|
|
|
|
|
|
2 In the work area, connect one end of a
3 Label the faceplate if it does not already have a cable label. Follow your enterprise’s procedures for cable labeling. If there is more than one wiring closet on a floor, record on the same line, the wiring closet identifier or location and the cable identifier.
4 In | the | wiring | closet, | connect the cable that | originated at the | ATM | device to | |
the appropriate connector on the patch panel or other | equipment | where the | ||||||
building | wiring | terminates. Connect the other end | of the | cable to | an | ATM | ||
port | on | the | module. |
|
|
|
|
5 Label the connector on the patch panel (or other equipment used to terminate the building wiring).