3Com 6412M-25-TP manual Network

Connecting

the Module

to

the

Network

When

you install

an 6412M-25-TP module,

it

is

by

default

set

to

Isolated mode

and

all

of

its

ports

are

disabled. When

a

module

is

isolated,

no

network activity takes

place

it

and

it cannot be accessed by

the network. This is a security measure that protec

your

ATM

network

from

unauthorized

access and module

dysfunction.

To

establish

the

module's

connection

to

the

network,

enter the

following command

at

the

ATM

console

prompt:

SET MODULE slot CONNECTED

whereslot specifies the slot number of the ONcore 12-Port 25 Mbps ATM I/O module.

The module's ports will not be enabled.			This	allows		you	to	configure		individual	ports
before enabling them. If you	wishall	portstoenableusing the current						values (either
the default values if the module		has	not	been	used,		or	the	previous values		entered),
enter the following command:
SET MODULE slot CONNECTED ENABLE
If you wish toindividualenable ports	using	the	current		values		(either		the	default values
if the module has not been used,		or	the	previous		values		entered),		enter the	following
command:

SET PORT slot.port ENABLE

3-6 25 Mbps ATM Module - Installation and User's Guide