3Com 7000HD manual Installation on, Module, 32MB Memory Upgrade Steps

	32MB MEMORY UPGRADE
2
	INSTALLATION ON THE
	COREBUILDER 7000HD SWITCH
	MODULE

32MB Memory

Upgrade Steps

Step 1 Removing the CoreBuilder 7000HD Switch Module from the Chassis

Before starting, make sure that you wearing the ESD wrist strap and

that you are properly connected to grounding equipment as described in “Safety Precautions” on page 1-2.

Disconnect the cables from the module’s ports. Ensure that there is a record of where the cables are attached so that you can correctly

￿re-connect them to the module when finished.

With the #1 flathead screwdriver supplied, loosen the two captive screws located on the far left and right of the module near the ejector handles (Figure 2-1). Do not remove the screws.