3Com 7000HD manual Verifying 32MB, Memory Upgrade

Verifying 32MB Memory Upgrade 2-9

Step 4 Returning the CoreBuilder 7000HD Switch Module back to the Chassis

Orient the Switch Module so its labelling is upright and make sure the eject handles are in the outward position.

Insert the module into the chassis by placing it in the guides of the selected slot and slide the module with two fingers until it stops. While inserting the module, raise it up a little and slide it in.

				Grab both ejector handles and push them inward. This locks the module
				into the chassis. You may have to apply considerable pressure to the
				handles. An audible “click” indicates that the connectors have engaged.
	￿￿￿￿￿￿￿￿￿￿￿￿#￿			Verify that the card has been properly installed by observing its LEDs.
			￿￿￿￿￿￿￿￿￿￿￿$		%%	%&'%(-$￿%').$￿-	￿￿￿￿		￿￿￿!"
				Tighten the module’s securing screws.
Verifying 32MB				To verify that the switch module’s memory has been upgraded
Memory Upgrade				successfully, follow the steps below:
				Reconnect all the cables to the switch module's ports according to
		￿￿￿￿		the record you made of the cables.						￿￿
				Reconnect the power cable
				Login to the LMA with the username: ￿￿￿￿￿.
				From the LMA of the CoreBuilder 7000HD Switch Module, select
				option￿￿￿￿￿￿￿￿￿￿￿￿￿*￿+,￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿and then select option
				The following￿information should be displayed:￿￿￿￿			￿￿	￿￿￿￿

Check that the memory shown is 32M.