Configuring VoIP
Parameters | These SoTCP map table parameters should be configured: |
Note
A node boot is required for changes to these parameters to take affect.
Entry Number
Range |
| 1 to 32 for PathBuilder S21x switch | |
|
| 1 to 64 for PathBuilder S24x, 26x, and 27x switch | |
|
|
|
|
Default | 1 | ||
|
|
|
|
Description |
| Specifies the number used to reference this table record. | |
|
|
|
|
Destination Address | |||
|
|
|
|
Range |
| 0 to 15 digits. | |
|
|
|
|
Default |
| blank | |
|
|
|
|
Description |
| Specifies the network address for calls for which TCP sessions | |
|
| must be established. Use space to blank the field. | |
|
|
|
|
Destination IP Address | |||
|
|
| |
Range |
| X.X.X.X. (Where X is between 0 and 255.) | |
|
| ||
Default | 0.0.0.0 | ||
|
| ||
Description | Specifies the unicast IP address of the node to which calls are | ||
|
| routed. Calls with a network address corresponding to this entry | |
|
| will establish a TCP session with this destination. | |
|
|
| Note |
|
|
| |
|
|
| |
|
| You may configure up to four destination IP addresses for each | |
|
| destination X.25 address. This allows a user to specify alternate | |
|
| destination IP addresses to connect to the same destination X.25 | |
|
| address. | |
|
|
|
|
|
|
|
|
Voice Over IP | 17 |
Revision 5.2 |