Programming the Transmitter
Step 3 |
| Step 4 |
| Step 5: Exit Program Mode |
|
|
|
|
|
Press the “Lock” button on the first | Repeat for each additional | When finished, turn Off the ignition |
transmitter until you hear a | transmitter. | key or wait for 15 seconds to get out |
confirmation chirp/beep. The |
| of transmitter programming mode. |
transmitter is now coded into the |
| You will hear 3 long chirps/beeps. |
system. |
| You are out of the transmitter |
|
| programming mode. |
Alarm Feature Programming
Examine the feature chart enclosed and decide which feature will get changed. Circling the feature to be changed will make the programming process much easier to perform.
Step 1 |
| Step 2 |
+
3X3X
With the ignition switch in the OFF position, turn the key
Within 10 seconds, push and release the valet switch 3 times. The siren/horn will emit 1 long chirp or beep. Push and release the valet switch 3 more times. The siren/horn will emit 1 long chirp or beep. You are now in “Alarm Feature Programming” mode.
Step 3
1.Press the valet switch the number of times required to access the feature that needs adjusting.
2.Press the indicated transmitter button and listen for the chirp sequence to set the feature.
Example:
-Complete steps 1,2 and 3 to enter feature program mode
-Push the valet switch 2 times, (Selects Manual/Automatic arm programming) the siren will chirp 2 times and the LED will flash 2 times.
-Change the feature to “Automatic Arming” by Pressing the 
button on the transmitter. The siren/horn will chirp 2 times.
7
