Concord 35
Sending a Police Panic Alarm
Your system can be set up so that you can send a Police panic alarm from a Touchtone phone. If
your system is set up to send a Police panic alarm:
•Use the *, regardless of your phone command key.
• Do not wait more than two seconds between key presses. Continue pressing * even if you
hear the system voice interrupt with a system status.
Police panic alarms can be activated from a Touchtone phone on the premises only. The alarm
cannot be activated from an off-site phone
Phone Questions?
What if someone calls while I’m operating the panel?
If the phone rings while you’re using it to operate the system, you’ll hear one long beep for each
ring from interior speakers and phones. You can answer the call by simply hanging up on the sys-
tem, then answering the call as you normally would.
You’ll have to initiate another session to resume operation.
Can I control the system while I’m talking on the phone?
No.
Step 2. Enter the command.
Disarm the system # + 1 + CODE
Arm to Level 2* # + 2 + CODE
Arm to Level 3* # + 3 + CODE
Send a Police panic alarm * + * + * + * + * + *
(Available from on-site only.)
Arm system with No Delay* # + 2 + CODE + 4 or
# + 3 + CODE + 4
Arm to enable Latchkey* # + 2 + CODE + 6 or
# + 3 + CODE + 6
Arm system with exit lights off* # + 2 + CODE + 0 or
# + 3 + CODE + 0
Bypass a sensor Indirectly: Arm system + # + #
Directly: # + # + CODE + Sensor Number
Arm silently* # + 5 + 2 + CODE or
# + 5 + 3 + CODE
Turn all lights on/off # + 0 + 0
Turn specific lights on/off # + 0 + Light number (1–9)
Cancel an accidental alarm # + 1 + CODE
Check the system status # + for short status
# + ** for full status
Turn Chime on/off # + 7 + 1
Turn Energy Saver on/off # + 7 + 2
Disable local phone access # + 7 + 3(on-site only) or
Wait 5 seconds after picking up a local phone.
Check alarm memory # + 7 + 6
Activate Outputs # + 7 + 7 + Output number (1–6)
* If Quick Arm feature is on, access code is not required. See page 6 for more information.