3M 200a Tape Roll Diameter, Tape Application Leg Length Standard, Box Board, Minimum Maximum

Specifications (Continued)

6.Tape Roll Diameter:

Up to 405 mm [16 inch] maximum on a 76.2 mm [3 inch] diameter core. (Accommodates all system roll lengths of Scotch™ brand film tapes.)

7.Tape Application Leg Length – Standard:

70 mm ± 6 mm [2 .75 inch ±.25 inch ]

Tape Application Leg Length – Optional:

50 mm ± 6 mm [2 inch ±.25 inch]

(See "Special Set-Up Procedure – Changing the Tape Leg Length", Page 23.)

8.Box Board:

Style – regular slotted containers – RSC

125 to 275 P.S.I. bursting test, single wall or double wall B or C flute.

9.Box Weight and Size Capacities:

A. Box Weight, filled – 2.3 kg [5 lbs.] minimum, 38.6 kg [85 lbs.] maximum.

B. Box Size:		Minimum	Maximum
Length –		150 mm [6.0 inch]	Unlimited
Width	–	150 mm [6.0 inch]*	550 mm [21.5 inch]
Height	–	120 mm [4.75 inch]** ***	620 mm [24.5 inch] ***

*Cartons narrower than 250 mm [10 inch] in width may require more frequent belt replacement because of limited contact area.

**90 mm [3.5 inch] height with heads adjusted to apply 50 mm [2 inch] tape leg lengths. (See "Special Set-Up Procedure – Changing the Tape Leg Length", Page 23.)

***165 mm [6.5 inch] minimum to 725 mm [28.5 inch] maximum height with columns adjusted to upper position. (See "Special Set-Up Procedure – Box and Machine Bed Height Range", Page 24.)

Special modifications may be available for carton sizes not listed above. Contact your 3M Representative for information.

Note: The case sealer can accommodate most boxes within the size range listed above. However, if the box length (in direction of seal) to box height ratio is .75 or less, then several boxes should be test run to assure proper machine performance.

DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:

BOX LENGTH IN DIRECTION OF SEAL	MUST BE GREATER THAN .75
BOX HEIGHT

Any box ratio approaching this limitation should be test run to assure performance.

(Specifications continued on next page.)

7