Receiver Overview
➊
➍ ➎ |
| ➒ |
|
➋➑
➌ ➏ ➐
1.Volume Control – Adjusts the volume of the receiver through three levels of audio and off.
2.Power Key – Powers the receiver on and off.
3.Peak Key – Toggles between Directional Peak and Single Peak antenna configuration.
4.Line Locate Key – Places the Receiver in Pipe/Cable locating mode and selects frequency. When toggled, it will cycle between 8 kHz, 82 kHz, and 60 Hz (Power Mode). (More frequencies are available in setup mode).
5.Sonde Locate Key – Places the receiver in sonde locate mode and selects sonde frequency. When toggled, it will cycle between 512 Hz and 33 kHz. More frequencies are available in setup mode.
6.Gain Adjust – Adjusts the sensitivity of the receiver either up (+) or down
7.Depth Key – Displays depth to target pipe/cable/sonde.
8.Setup Key – Configure receiver depth units, enable/disable line and sonde frequencies, select 50/60 Hz power frequencies.
9.Bulb Key – Turns the display backlight on and off.
