![](/images/new-backgrounds/1255633/25563353x1.webp)
22
Operational Check | Operational |
Check | |
Operating sequence |
|
Operating sequence
1.Turn Flow On in the setup menu of the QUESTemp°46.
2.Plug the Air Probe into the port labeled Flow on the side of the QUESTemp° 46.
3.Turn on the Air Probe ON and make sure the green lamp is lit.
• In the View or Run modes, airflow is displayed on the fifth screen.
Data Logging Airflow
To data log airflow in the QUESTemp° 46, the following two conditions must be met.
1.First, turn Flow On in the setup menu.
2.Second, make sure that a temperature sensor bar is connected to the Sensor 1 location (top) of the QUESTemp°46. Flow prints out with the Sensor 1 data therefore airflow data will only be reported if a sensor bar is plugged in. Airflow is recorded during the run mode at the interval the QUESTemp° 46 is setup for.
Batteries for Air Probe
The Air Probe uses a single NiMH Black&Decker VersaPak Gold battery. Typical operating time of the battery is between 6 and 8 hours.
To change the battery, push in and twist, counterclockwise, the cap on the bottom of the Air Probe. Pull out the battery. Insert a fully charged battery and replace the cap.
To recharge the batteries, set the battery into the VersaPack charger. The supplied charger accepts one or two batteries. A full charge takes 9 hours. An indicator light shows that the battery is properly charging and it will remain on as long as the battery is in the charger. Continuous charging is not a safety concern.
Operational Check
A verification module, 3M model
If the readings are not within the