19

Power options

Powering

9-Volt Alkaline Battery Replacement

Powering

The QUESTempº 48N uses a 9-volt alkaline battery. A door on the back of the instrument allows the user access to the 9-volt battery.

The 2-position switch located in the battery compartment is set by the user to the 9-volt battery.

Figure 1-31: 9-volt battery

9-Volt Alkaline Battery Replacement

WARNING: Replace batteries only in a non-hazardous environment.

The 9-volt battery should be replaced should be recharged when the voltage drops below 6.4 volts. The battery voltage is displayed when the instrument is turned on. While turned on, the battery voltage can be displayed at any time by pressing the up or down arrow keys to move through the display until the battery voltage screen appears. If, while operating, the battery voltage drops below 6.4 volts, the display will automatically switch to the display showing the battery voltage along with a low battery message. After a low battery occurs, the unit will continue to operate for approximately 8 hours. When the battery voltage falls to 6.2 volts or below, the unit will automatically turn off.

Replace only with an approved 9-volt alkaline battery.

Approved 9-Volt Batteries

Eveready: Energizer 522, EN22, 6LR61

Duracell: MN1604

Panasonic: 6LR61, 6AM6X

Rayovac: A1604

UltraLife: U9V

Page 23
Image 23
3M 48N user manual Powering, Volt Alkaline Battery Replacement, Approved 9-Volt Batteries, Duracell MN1604