3M™ Digital Media System 800 Series | Installation and System Setup | |
|
|
|
13.(Digital Media System 815 Only) Attach the Annotation Pod as shown on pages
14.Start up the projector by switching on the main
power switch, then pressing the power button on the projector, the control panel or the remote.
Main Power Switch | Power Button |
ENGLISH
15.Adjust the projector arm length to achieve the desired image size. Extend the section of the arm closest to the base first by loosening the clamp, sliding the arm out, and tightening the clamp. Extend the second section of the arm as needed.
16.Focus the image by turning the projection focus ring.
17.To adjust the position of the image on the screen, refer to the Digital Media System 800 Series Image Alignment Guide.
18.To remove the projector from the wall, remove the right speaker grill and pull the locking ring out. Carefully lift the projector off the mounting plate.
Note: The locking ring may be temporarily retained in the unlocked position by sliding it into the recess in the corner of the speaker housing.
Extend this section first
Extend this section last
Projection Focus Ring 
© 3M 2007. All Rights Reserved. | 15 |