3M™ Digital Media System 800 Series | Introduction | |
|
|
|
WARNING
•To reduce the risk associated with hazardous voltage:
-Do not remove any screws other than those specified in the lamp replacement instructions.
-Always plug projector into a grounded outlet.
-Do not use in wet environments.
-Do not use in an outdoor environment.
-Replace the power cord if damaged.
-Do not attempt to service the projector other than performing routine lamp replacement. Service should only be performed by a 3M authorized service provider. Aside from the projection lamp module, there are no user serviceable parts inside the unit.
-Do not modify this projector or power cord.
-Disconnect power cord when the projector is not in use, during lamp replacement, and while cleaning.
-Do not allow water or other liquids to enter the projector.
•To reduce the risk associated with hazardous voltage and/or fire:
-Use a properly rated extension cord. Consult an electrical professional if you have questions.
•To reduce the risk associated with hot surface of lamp cartridge:
-Wait at least 60 minutes for the lamp assembly to cool before replacing.
•To reduce the risk associated with choking:
-Keep batteries away from children and pets.
•To reduce the risk associated with environmental contamination due to mercury:
-Hg: Lamp in this product contains mercury. Dispose of lamp according to local, state, or federal laws. See www.lamprecycle.org or call
•To reduce the risk associated with lamp rupture related hazards:
-In event of lamp rupture, call 3M authorized service provider for repair. Ruptured lamp repair is not user serviceable.
-Wash your hands thoroughly if contact with ruptured lamp debris has taken place.
-Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
•To reduce the risk associated with hazard voltage, and/or impact, and/or tripping, and/or intense visible light:
-Do not use this projector around unsupervised children.
•To reduce the risk associated with muscular strain:
-Always use more than one person when installing or removing the projector.
•To reduce the risk associated with impact, and/or pinch:
-Use only 3M supplied wall mounting hardware.
-Follow all installation instructions carefully.
-Make sure mounting hardware is securely anchored to a solid structure.
-Make sure set screws are properly secured to wall mounting plate.
•To reduce the risk associated with impact:
-Use only on smooth or level flat surfaces.
-Do not use on a structure that is prone to vibration, movement, or chance of impact.
-Do not hang on, or place weight on the projection arm.
•To reduce the risk associated with various hazards related to the projector:
-Please read, understand and follow all safety information contained in the operator and product safety guide prior to installation and use.
•To reduce the risk associated with sharps, premature lamp failure, exposure to mercury:
-Always handle the fragile lamp module with care.
-Replace the lamp module when the lamp replacement message appears.
-Never replace the lamp module with a previously used lamp module.
•To reduce the risk associated with radio interference
-This is a Class A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.
ENGLISH
© 3M 2007. All Rights Reserved. | 7 |