Chapter 2: Installing the monitor

Important

If security screws are used, the operator will not be able to access the enclosure without a security screwdriver. This means that the operator may be unable to perform such tasks as changing display settings.

The locations for attaching the security screws are shown in Figure 13 on page 38.

Mounting the ET 350 monitor with Moisture Deflector

The ET 350 monitor with Moisture Deflector comes with four sealing screws fastened to the back of the unit. 3M Touch Systems recommends that if you need to remove the sealing screws to access the enclosure, you re-attach the screws after closing the enclosure.

The ET 350 monitor with Moisture Deflector must be mounted vertically—with no more than 10 degrees variance from vertical—for the Moisture Deflector to operate. As long as the 10 degree rule is observed, it is possible to mount the monitor with the Moisture Deflector using any of the mounting kits described above.

29