3M Dynapro ET 350 Monitor User’s Installation Guide
ProblemSolution
ET 350 monitor does not power up when plugged in.
Try the following:
1.Make sure that the power to the monitor’s power cable is turned on.
2.Make sure that the power to the host computer’s power supply is turned on.
3.Check that the power cord is properly connected at both ends.
4.Check the fuse (see “Replacing the fuse” on page 32).
5.Plug the power cable back into the monitor and restore power to the cable.
After manually aligning the | • | Try downloading the standard |
TouchSurround buttons, |
| TouchSurround button definition file |
alignment of the touch screen is |
| (see “Importing standard |
unsatisfactory. |
| |
|
| page 24) and then customize the |
|
| button definition files as required. For |
|
| instructions on customizing, refer to |
|
| the appropriate software guide (see |
|
| |
|
| page 3). |
|
|
|
Touch screen not functioning. | • | Make sure that the touch drivers are |
|
| installed properly. |
| • | Read the touch screen driver error |
|
| messages (below) and follow the |
|
| applicable instructions. |
|
|
|
Keyboard/mouse not functioning | • | Refer to the “keyboard/mouse” |
for the ET 350 monitor with KVM |
| section of the troubleshooting chapter |
extender option. |
| in the KVM extender manufacturer’s |
|
| manual.* |
*Note: References to “serial device” in the KVM manufacturer’s manual denote the “touch screen” of the ET 350 monitor.
46