USING THE REMOTE CONTROL (continued)
Operating the remote control
WARNING • The laser pointer of the remote control transmitter is used in
place of a finger or rod. Never look directly into the laser beam outlet or point the laser beam at other people. The laser beam can cause vision problems.
CAUTION • Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
• The remote control works with both the |
|
|
|
|
|
|
projector's front and rear remote sensors. |
|
|
|
|
|
|
• The range of the remote sensor on the front is 3 |
|
|
|
|
|
|
meters with a |
|
|
|
|
|
|
left and right of the remote sensor), and back is 3 |
|
|
|
|
|
|
meters with a |
| degrees | degrees |
| degrees |
|
• Since the remote control uses infrared light to send | 30 |
| degrees | |||
signals to the projector (Class 1 LED), be sure to use |
| 30 | 20 | |||
approximately |
|
|
| 20 | ||
the remote control in an area free from obstacles | 3 meters |
|
| approximately | ||
|
|
| ||||
|
|
| 3 meters |
|
| |
that could block the remote control's output signal to the projector.
•The wired remote control:
You can use the remote control as a wired remote control, by connecting the REMOTE CONTROL ports of the main unit and remote control via an audio cable (3.5 dia. stereo mini cable with plugs).
ATTENTION Precautions to observe when using the remote control
•Do not disassemble the remote control.
•Do not drop or otherwise expose the remote control to physical impact.
•Do not get the remote control wet or place it on wet objects. Doing so may result in malfunction.
•Do not place the remote control near the projector’s lens, fan, or vents.
•Remove the batteries from the remote control and store them in a safe place if you won't be using the remote control for an extended period.
•Replace the batteries whenever the remote control starts to malfunction.
•When strong light, such as direct sunlight or light from an extremely close range (such as from an inverter fluorescent lamp), hits the projector's remote sensor, the remote control may cease to function. Adjust the direction of the projector to keep light from directly hitting the projector's remote sensor.
14
