TURNING OFF THE POWER
LASER
INDICATOR
STANDBY/ON VIDEO RGB
| UP |
FOCUS ZOOM | PAGE |
| DOWN |
BLANK | LASER |
ASPECT
PUSH
ENTER
ESC MENU RESET
POSITION AUTO PinP
MAGNIFY | VOLUME |
ON |
|
FREEZE | MUTE |
OFF |
|
WIRELESS KEYSTONE | ONE TOUCH |
Control panel
1 | Press the STANDBY/ON button (control | |
| panel or remote control) |
|
| The message "Power off?" will appear on the screen for | STANDBY/ON |
| approximately 5 seconds. |
|
2 | Press the STANDBY/ON button again |
| (control panel or remote control) |
Press the STANDBY/ON button again while the "Power off?" message is visible. The projector lamp goes off and starts cooling down. While cooling, the STANDBY/ON indicator flashes orange. When in this state, pressing the STANDBY/ON button has no effect.
When lamp cooling is complete, the STANDBY/ON indicator stops flashing, and turning solid orange.
STANDBY/ON
3 | Check that the STANDBY/ON indicator | |
| stops blinking and lights to | power switch |
| solid orange. | |
|
| |
| Switch the power switch to |
|
| [O] (OFF). |
|
STANDBY/ON indicator
NOTE
•Except in cases of emergency, do not turn off the power switch while the STANDBY/ON indicator is solid or flashing green. Doing so could shorten the lamp lifetime.
4 | Confirm that the STANDBY/ON indicator has |
| gone off and then attach the lens cap. |
When the projector has completed powering down, the STANDBY/ON indicator will go off.
17
