3M SCP7112 Maintenance, Installing or Replacing Batteries, Note:

1 24

3M™ Super Close Projection System SCP712

Operator’s Guide

1.Push on the cover and slide it upward to unlatch it.

2.Remove the cover.

3.Install two AAA batteries with the correct polarities and then replace the cover. Slide it downward until it locks into place.

Note: Verify the battery cover is fully latched before
using the remote control.	Installing Batteries

Contents

Page Table of Contents INTRODUCTION Thank you for choosing 3M equipment Important Notice Product Patents Regulatory Notices Safety Information Intended Use SAVE THESE INSTRUCTIONS Contents of Shipping Box Optional Accessories (not shown) Keep Your Packing Materials What’s Next Product Description Machine Characteristics Parts Identification Terminal Connections I/O Module Terminal Connections (optional accessory) Setup and System Configuration Machine Specifications Operating Instructions Projector Start Up Stand By Mode Start Up Menu Navigation Main Menu Input Menu Picture Menu Picture Menu – Advanced Audio Menu Setup Menu Information Menu Remote Control Functions Maintenance Installing or Replacing Batteries Lamp Replacement Troubleshooting Common Problems and Solutions Technical Support Contact: