3M™ Super Close Projection System SCP712 | Operator’s Guide |
WARNING
English
•To reduce the risk associated with exposure to hazardous voltage:
-Do not remove any screws other than those specified in the lamp replacement instructions.
•To reduce the risk associated with hazardous voltage:
-Do not operate this projector in wet environments or outdoors.
-Do not modify this projector or power cord.
-Do not attempt to service the projector; other than the lamp cartridge there are no user serviceable parts inside the projector.
-Contact a 3M authorized service provider for service.
-Disconnect power cord when the projector is not in use, during lamp replacement, and while cleaning.
-Do not allow water or other liquids to enter the projector.
•To reduce the risk associated with hazardous voltage and/or fire:
-Replace power cord if damaged.
-Contact a 3M authorized service provider if the projector becomes damaged.
-Use a grounded extension cord with a rating at least equal to that of the projector.
-Connect this projector to a grounded outlet.
•To reduce the risk associated with hot surface of lamp cartridge:
-Unplug the projector from the electrical outlet and allow the lamp to cool for 60 minutes before replacing the lamp.
•To reduce the risk associated with choking:
-Keep the battery and battery cover away from children and pets.
•To reduce the risk associated with environmental contamination due to mercury:
-Hg: Lamp contains mercury. Don't throw in trash. Dispose according to local, state, or federal laws. See www.lamprecycle.org or call
•To reduce the risk associated with lamp rupture related hazards:
-In event of lamp rupture, call 3M authorized service provider for repair. Ruptured lamp repair is not user serviceable.
-Wash your hands thoroughly if contact with ruptured lamp debris has taken place.
-Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
•To reduce the risk associated with hazard voltage, and/or impact, and/or tripping, and/or intense visible light:
-Do not use this projector around unsupervised children.
•To reduce the risk associated with sharps, premature lamp failure, exposure to mercury:
-Always handle the fragile lamp module with care.
-Replace the lamp module when the lamp replacement message appears.
-Never replace the lamp module with a previously used lamp module.
CAUTION
•To reduce the risk associated with intense visible light:
-Avoid looking directly into the projector lens while the lamp is on.
•To reduce the risk associated with impact of a falling projector:
-Use only the 3M brand wall/ceiling mounting hardware kit if wall or ceiling mounting is desired.
-Installation of the 3M brand wall/ceiling kit must only be performed by qualified personnel.
-Adhere strictly to the proper installation procedure as outlined in the installation instructions when installing the 3M wall/ceiling kit.
-Always operate the unit on a flat, sturdy, and horizontal surface.
•To reduce the risk associated with explosion, and/or chemicals from leaking battery:
-Use only with battery type AAA.
-Orient the battery’s plus (+) and minus
-Do not leave the battery in the remote for an extended period of time.
-Do not heat, disassemble, short, recharge, or expose the batteries to fire or high temperature.
-Do not carry batteries loose in your pocket or purse.
-Avoid eye and skin contact in the event that battery would leak.
-Do not mix used and new batteries.
•To reduce the risk associated with tripping, and/or impact:
-Position the power cord and data cable so that they can not be tripped over.
•To reduce the risk associated with environmental contamination due to battery chemicals:
-Dispose of exhausted batteries in accordance with applicable federal, state and local regulations.
SAVE THESE INSTRUCTIONS
♥ 3M 2008. All Rights Reserved. | 5 |