3M S55, X45, X55 About the filter cover for bottom-upuse, To remove, To set, Filter cover for

Setting up

About the filter cover for bottom-up use

WARNING ►Do not replace the filter cover during use or immediately after use. While the projector connects with a power supply, or the projector is in a high temperature state, handling could cause an electric shock, a fire, a burn and/or malfunction to the projector.Before handling, make sure the power switch is off and the power cord is not plugged in, then wait at least 45 minutes.

When the projector is installed bottom up, please use the accessory filter cover for bottom-up use. It is higher than usual filter cover, to keep the space for intake ventilation. Please change in the following procedure.

To remove		To set
	Filter cover	Filter cover for
		bottom-up use

Filter cover’s claw Filter cover’s claw

1. After making sure that the projector is cool adequately, slowly turn the projector so that the lens-side is facing up. Please be careful for a projector

not to fall. While the projector is placed lens-side up, hold the projector.

2. Please unhook the claw of the filter cover using a minus screwdriver or similar, and remove the filter cover.

3. Replace the filter cover for bottom-up use and snap it back into place.

4. Slowly turn the projector so that the top is facing up.

10