4.When the green power light stops flashing, make sure paper is loaded in the printer, then do the following:

Windows: Click Print Nozzle Check Pattern. Then click Print.

Macintosh: Click Confirmation, then click Next. The nozzle check pattern prints.

5.If the nozzle check pattern has no gaps or white lines as shown, click Finish.

If the pattern has gaps, click Clean to clean the print head again.

You can also turn the printer off and wait overnight—this allows any dried ink to soften— and then try cleaning the print head again.

■The ink cartridges may need replacing; see page 21 for instructions.

Your printout is blurry or smeared.

■Make sure the printable (whiter) side of the paper is face-up.

■Use Epson papers to ensure proper saturation and absorption of genuine Epson ink.

Your paper doesn’t feed correctly or jams in the printer.

■If multiple pages feed at once, remove the paper from the sheet feeder, fan the edges to separate the sheets, then reload it.

■If paper jams, press the paper button for several seconds to clear the jam. If that doesn’t work, open the cover and pull the paper out from the front, including small pieces that may have torn off. Reload the paper and press the paper button.

■Heavily saturated prints may curl, causing a paper jam when printing on both sides of the paper.

■Make sure you use new, smooth, high-quality paper, loaded printable side up. Don’t load paper above the arrow mark inside the left edge guide. Place the paper against the right edge, behind the tab. Slide the left edge guide against it, but not too tightly.

Problems and Solutions 29