A&D SK-30KWP Preparation, Installing Batteries / Connecting the AC Adapter, Setting up the Scale

PREPARATION

Installing Batteries / Connecting the AC Adapter

Installing Batteries

CAUTION When replacing batteries, be careful not to apply too much force to the weighing platform. An excessive force could damage the scale.

Unlock and remove the battery cover. (See illustration at the right) Insert six new batteries (R20P / LR20 / D size) into the battery compartment, taking extreme care to that the plus and minus polarities are observed.

Be sure to install and lock the battery

cover after installing the batteries. New six batteries. (R20P/ LR20/ D size)

AC Adapter (Optional)

CAUTION When using an AC adapter, the

scale doesn’t comply with IP65. The AC input requirement

could be 100, 120, 220, 230 or 240 volts (50/60Hz) depending on the area where used, so please verify that the adapter is the correct type.

Plug the AC adapter to the AC adapter socket inside the battery compartment.

Setting up the Scale

CAUTION Avoid installing the scale in direct sunlight, that may cause discoloration or malfunctions. Place your SK-WP on a firm weighing table so that the scale is level. The scale will not perform accurately when it is not level.

Place the scale on a firm surface and adjust the feet to level the scale, while using the sprit level, for accurate weighing.

- 3 -