Using the Monitor, Installing / Changing the Batteries

Using the Monitor

1.Slide the battery cover up to open it.

2.Remove the used batteries and insert new batteries into the battery compartment as shown, taking care that the polarities (+ and -) are correct.

Use only R6P, LR6 or AA batteries.

3.Slide the battery cover down to close.

CAUTION

Step 3

Step 1

Step 2

Insert the batteries as shown in the battery compartment. If installed incorrectly, the device will not work.

When				(LOW BATTERY mark) blinks on the display, replace all batteries

with new ones. Do not mix old and new batteries. It may shorten the battery life, or cause the device to malfunction.

Wait two seconds or more after turning the device off, to replace the batteries.

If				(LOW BATTERY mark) appears even after the batteries are replaced, make

a blood pressure measurement. The device may then recognize the new batteries. (LOW BATTERY mark) does not appear when the batteries are drained.

The battery life varies with the ambient temperature and may be shorter at low temperatures.

Use the specified batteries only.

Remove the batteries if the device is not to be used for a long time. The batteries may leak and cause a malfunction.

Insert the air connector plug	Air socket
into the air socket firmly.
	Air connector plug

Insert the AC adapter plug into the DC jack.

Next, connect the AC adapter to an electrical outlet.

Use the specified AC adapter. (Refer to page 18.)

DC jack

AC adapter plug