Aastra Telecom CT9143i manual XML Applications and Off-Hook Interaction

SIP IP Phone Models 9143i, 9480i, 9480i CT and 5i Series Phones Release Note 2.3

New Features in Release 2.3

	XML Applications and Off-Hook Interaction
	In Release 2.3, a feature has been implemented that prevents the phone from going into the
	off-hook/dialing state when the handset is off-hook and the call ends.
	In previous releases, the phone behaved as in the following scenario:
	You are in a call using the handset and the phone displays an XML application. The far-end
	terminates the call, and a new XML application gets pushed/pulled onto the display. Since the
	handset is off-hook and in idle mode, the "offhook idle timer" starts. When this timer expires, the
	phone applies dial tone and moves to the off-hook/dialing state, which then destroys the XML
	application that was being displayed.
	In Release 2.3, you can set an “auto offhook” parameter that determines whether or not the phone
	is prevented from entering the off-hook/dialing state, if the handset is off-hook and the call ends.
	An Administrator can enable or disable the “auto offhook” parameter using the configuration files
	only.
	Configuring the Off-Hook Interaction Feature
	Use the following parameter to configure the XML application and off-hook interaction feature.
Parameter–		Configuration Filesaastra.cfg, <mac>.cfg
auto offhook
Description		Specifies whether or not the phone is prevented from entering the off-hook/
		dialing state, if the handset is off-hook for more than 2 seconds, and the call
		ends.
Format		Boolean
Default Value		0 (disabled)
Range		0 (disabled)
		1 (enabled)
Example		auto offhook: 1

RN-001029-02, Release 2.3, Rev 00 41