AB Soft MS6 SERIES user manual Opal Pro Parameter Settings, Opal Pro Setting Description Parameter

Opal Pro to Mod TCP

Opal Pro Parameter Settings

The parameters in the Opal Pro used to configure the Ehernet interface card (group 14) are only accessible if a Ethernet interface card is installed. The parameter settings are as follows:

Opal Pro		Setting	Description
Parameter
2.02 Comm Module		Ethernet	Type of interface card installed
			(read only)
10.01	Start/Stop	Comm	This allows the Opal Pro to be
		Module	started and stopped over the
			communication link
10.04	Iref Source	Comm	If this is set to Comm Module the
		Module	Opal pro will follow the Current
			reference from the communication
			link. If there is no reference being
			sent on the communication link this
			should be set to “Internal”
10.05	Phase Angle	Comm	If this is set to Comm Module the
Source		Module	Opal pro will follow the Phase Angle
			reference from the communication
			link. If there is no reference being
			sent on the communication link this
			should be set to “Internal”
14.07	Node	1 – 254	This is the Node # of the slave Opal
			Pro
14.08	IP Addr 1	0-255	First number in the IP address of
			the Opal Pro
14.09	IP Addr 2	0-255	Second number in the IP address of
			the Opal Pro
14.10	IP Addr 3	0-255	Third number in the IP address of
			the Opal Pro
14.11	IP Addr 4	0-255	Fourth number in the IP address of
			the Opal Pro. (the node number as
			set in 14.07 is added on to this
			number to get the final IP address)
14.12	SubNet 1	0-255	First number in the SubNet Mask
14.13	SubNet 2	0-255	Second number in the SubNet
			Mask
14.14	SubNet 3	0-255	Third number in the SubNet Mask
14.15	SubNet 4	0-255	Fourth number in the SubNet Mask

Page 8