Abit IS7-M, IS7-G, IS7-E2V, IS7-E2G, IS7-V2 user manual

Hardware Setup 2-21

(13). Floppy Disk Drive Connector

This connector supports two standard floppy disk drives via a 34-pin 34-conductor ribbon cable.

Connecting the Floppy Disk Drive Cable:

1.Install one end of the ribbon cable into the FDC1 connector. The colored edge of the ribbon cable should be aligned with pin-1 of FDC1 connector.

2.Install the other end(s) of ribbon cable into the disk drive connector(s). The colored edge of the ribbon cable should be also aligned with pin-1 of disk drive connector. The endmost connector should be attached to the drive designated as Drive A.

IS7-G/IS7/IS7-E:

IS7-M/IS7-E2/IS7-E2G/

IS7-E2V/IS7-V2:

IS7-M: IS7-E2/IS7-E2G/IS7-E2V: IS7-V2:

User’s Manual