AC International SV01B Motor Stator 4.00, Current Loop 9990, If P300 = 2...5, motor calibration

Commissioning

Code		Possible Settings					IMPORTANT
No.	Name	Default Selection
(1)	Motor Stator	0.00	0.00		{W}	4.00	• Will be automatically programmed by
	Resistance						P399
(1)	Motor Stator	0.0	0.0		{mH}	2000	• Changing these settings can
	Inductance						adversely affect performance.
							Contact factory technical support
							prior to changing
	Torque Limit	100	0		{%}	400	When P300 = 5, sets the maximum
							output torque.
	Preset Torque	100	0		{%}	400	TB-13A activated; P121 = 3 and
	Setpoint #1						P300 = 5
	Preset Torque	100	0		{%}	400	TB-13B activated; P122 = 3 and
	Setpoint #2						P300 = 5
	Preset Torque	100	0		{%}	400	TB-13C activated; P123 = 3 and
	Setpoint #3						P300 = 5
(1)	Current Loop P	0.25	0.00			.0
	Gain						Changing these settings can adversely
(1)	Current Loop I	65	12		{ms}	9990
							affect performance. Contact factory
	Gain
							technical support prior to changing.
	Speed Loop	0.0	0.0		{%}	20.0
(1)
	Adjustment
	Motor Auto-	0	0	Calibration Not Done			• If P300 = 2...5, motor calibration
	calibration						must be performed, but motor data
			1	Calibration Enabled			must be programmed first
							• An alternating	/	will occur if:
							- motor calibration is attempted with
			2	Calibration Complete			P300 = 0 or 1
							- motor calibration is attempted
							before programming motor data

Note

To run the Auto Calibration:

-Set P302...P306 according to motor nameplate

-Set P399 = 1

-Make sure motor is cold (20° - 25° C)

-Apply a Start command

-Display will indicate for about 40 seconds

-Once the calibration is complete, the display will indicate ; apply another Start command to actually start the motor

-Parameter P399 will now be set to 2.

(1)Any changes to this parameter will not take effect until the drive is stopped

28 ENGLISH