Accton Technology ES4324 manual Installing an Optional SFP Transceiver

Installing an Optional SFP Transceiver 3

2.Set the device on a flat surface near an AC power source, making sure there are at least two inches of space on all sides for proper air flow.

3.If installing a single switch only, go to “Connecting to a Power Source” at the end of this chapter.

4.If installing multiple switches, attach four adhesive feet to each one. Place each device squarely on top of the one below, in any order.

Installing an Optional SFP Transceiver

8

9 10 11 12

9 20

21 22 23 24

21

22

23

24

Figure 3-5 Inserting an SFP Transceiver into a Slot

The switch supports the following optional transceivers:

•1000BASE-SX

•1000BASE-LX

•1000BASE-LH

To install an SFP transceiver, do the following:

1.Consider network and cabling requirements to select an appropriate transceiver type. Refer to “Connectivity Rules” on page 4-6.

2.Insert the transceiver with the optical connector facing outward and the slot connector facing down. Note that SFP transceivers are keyed so they can only be installed in one orientation.

3.Slide the transceiver into the slot until it clicks into place.

Note: SFP transceivers are hot-swappable. The switch does not need to be powered off before installing or removing a transceiver. However, always first disconnect the network cable before removing a transceiver.

Note: SFP transceivers are not provided in the switch package.

3-5