Connecting to a Power Source | Accton Technology ES4324 guide

3 Installing the Switch

Connecting to a Power Source

To connect a device to a power source:

1.Insert the power cable plug directly into the socket located at the back of the device.

100-240V ~50-60Hz 0.8A

Figure 3-6 Power Socket

2.Plug the other end of the cable into a grounded, three-pin, AC power source.

Note: For international use, you may need to change the AC line cord. You must use a line cord set that has been approved for the socket type in your country.

3.Check the front-panel LEDs as the device is powered on to be sure the Power LED is on. If not, check that the power cable is correctly plugged in.

3-6

Image 34

Accton Technology ES4324 manual Connecting to a Power Source, Power Socket

Contents

Powered by Accton Page Port Gigabit Lite Switch ES4324 E092007-AP-R01 150200057600A Compliances and Safety Warnings CE Mark Declaration of Conformance for EMI and Safety EEC Safety Compliance Or Nema 6-15P 15 A, 250 V configuration France et Pérou uniquement Die Aufschrift HAR oder Basec tragen Environmental Statement Viii Contents Making Network Connections Appendix a TroubleshootingAppendix C Specifications Appendix B Cables Tables Figures Introduction Overview Network Management Options Switch ArchitectureDescription of Hardware 10/100/1000BASE-T Ports Port and Power Status LEDs LED Connectivity Features and BenefitsPower Supply Socket Expandability Management Introduction Introduction to Switching Network Planning Application Examples Collapsed Backbone Central Wiring Closet Central Wiring Closet Remote Connections with Fiber Cable Remote Connections with Fiber Cable Making Vlan Connections Vlan Application Notes Selecting a Site Installing the SwitchEthernet Cabling Package Contents Equipment ChecklistOptional Rack-Mounting Equipment Mounting Rack Mounting Installing the Switch in a Rack Desktop or Shelf Mounting Installing an Optional SFP Transceiver Inserting an SFP Transceiver into a Slot Connecting to a Power Source Power Socket Twisted-Pair Devices Connecting Network DevicesMaking Network Connections Cabling Guidelines Connecting to PCs, Servers, Hubs and Switches Making Twisted-Pair Connections Network Wiring Connections Wiring Closet Connections Fiber Optic SFP Devices Making Connections to SFP Transceivers 1000BASE-T Cable Requirements Connectivity RulesMbps Gigabit Ethernet Collision Domain Mbps Fast Ethernet Collision Domain Mbps Ethernet Collision Domain Cable Labeling and Connection Records Diagnosing Switch Indicators Appendix a TroubleshootingPower and Cooling Problems Installation In-Band Access Twisted-Pair Cable and Pin Assignments Appendix B Cables10BASE-T/100BASE-TX Pin Assignments Straight-Through Wiring Cables Crossover Wiring 1000BASE-T Pin Assignments Adjusting Existing Category 5 Cabling to Run 1000BASE-T Cable Testing for Existing Category 5 CableFiber Standards Appendix C Specifications Physical Characteristics Management Features Switch FeaturesStandards Compliances Specifications Glossary Fast Ethernet End StationEthernet Full Duplex LAN Segment Media Access Control MACIeee 802.3z Layer Switched Ports Redundant Power Supply RPSRJ-45 Connector Transmission Control Protocol/Internet Protocol TCP/IP Index Numerics Index-2 Page ES4324 E092007-AP-R01 150200057600A